In-situ TROLL 9500 O-ring Maintenance Kit (instruments les Manuel d'utilisateur télécharger pdf

Information Sheet

Due to continuing product development this information is subject to change without notice. In-Situ, the In-Situ logo, and TROLLare registered

1 800 4INSITU

(toll-free, US and Canada) or 970 498 1500 www.in-situ.com

Multi-Parameter

Water Quality

TROLL

DESCRIPTION

The instrument’s Viton® o-rings help to insure a water-tight seal. If the o-rings

appear worn, dried, nicked, stretched, cracked, etc., they should be replaced. If in

any doubt, it is best to err on the side of safety and replace them.

The kit includes dust caps, sensor port plugs, lubricant, and o-rings in the following

sizes (small to large):

0.301” I.D., 0.441" O.D. (#011), for sensors and sensor port plugs (qty: 8)

0.364" I.D., 0.504" O.D. (#012), for back end cable connector (qty: 2)

1.176" I.D., 1.316" O.D. (#025), for top of battery compartment (qty: 2)

1.489” I.D., 1.629" O.D. (#029), 2 at bottom of battery compartment, 1 on nose cone

(qty: 4)

38 mm I.D., 42 mm O.D., 2 mm thick, for front end of body, seal to restrictor and Cal

Cup (qty: 2)

REPLACEMENT PROCEDURE

1. Use your fingers or a non-metallic tool to remove the worn o-rings from the grooves.

2. Clean all mating surfaces with a swab or lint-free cloth.

3. Using your fingers, apply lubricant evenly to new o-rings.

4. Place the o-rings in the grooves. Remove excess lubricant.

GUIDELINES & PRECAUTIONS

• Be careful not to transfer grease from your fingers to the pins in the cable

connector, or to the sensor connectors and sensor port connectors. Any

lubricant in these areas should be removed with a clean cotton swab.

• Always use a dust cap to protect the o-ring and connector when cable is not

attached.

• The kit includes sensor port plugs for deployments with fewer than 4

removable sensors installed.

MP TROLL 9500

MAINTENANCE KIT

Catalog No. 95100

0095102 10/05

Every sensor port must be

occupied by a sensor or plug

before submersion.

The o-rings labeled D and E are

nearly identical in size. However,

E is slightly thicker than D

Actual Size

BCD

Sensor port

plug

Dust cap

MP TROLL 9500 1
MAINTENANCE KIT 1

Résumé du contenu

Page 1 - MAINTENANCE KIT

Information SheetDue to continuing product development this information is subject to change without notice. In-Situ, the In-Situ logo, and TROLLare r

Commentaires sur ces manuels

Pas de commentaire

In-situ TROLL 9500 O-ring Maintenance Kit (instruments les Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour l'eau In-situ TROLL 9500 O-ring Maintenance Kit (instruments les. In-Situ TROLL 9500 O-ring Maintenance Kit (instruments less than 2 diam.) User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour l'eau In-situ TROLL 9500 O-ring Maintenance Kit (instruments les